Actions
Bug #82
closed
Non-Pololu only assembly unclear?
Status:
Rejected
Priority:
Normal
Assignee:
-
Category:
Documentation
Target version:
-
Start date:
2013-05-08
Due date:
% Done:
0%
Estimated time:
Description
I'm converting a Morntech lasercutter to Laos. It already has stepper drivers so I'm trying to use those.
I find the following unclear though.
Some voltage: you can use Vmot by filling the solder pad under the connector (the square pole is +). If you need 3V3 you can make a wire between the pololu pins (10) and (14). If you need 5V, you can make a wire from a 5V net to pololu pin (14).
I don't have pololu's, so I'm not sure what pins are pololu pin 10 and 14.
If someone could explain I'll take a picture of the setup.
Updated by jaap almost 11 years ago
- Status changed from New to Rejected
I think you are far more likely to get answers to your questions on the forum. The layout of Pololu stepper drivers is well known by Google, you might want to try that first.
Since I do not consider this a "bug" in the documentation, i close this. Feel free to add additional information to the wiki if you find it.
Actions