LAOS - Laser Open Source

2015-07-27

10:18 LAOS Laser Discussion and support: RE: Scale problem visicut

Hi,
in VisiCut under the lasercutter-settings, you can set a path for the LGC file, so VisiCut will save the file ... t-oster

2014-10-26

10:40 LAOS Laser Discussion and support: RE: Laser mis-fires ...

Hi,
what needs to be done in VisiCut to automatically circumvent the issue? I could update the VisiCut driver, whi... t-oster

2014-08-29

18:40 LAOS Laser Discussion and support: RE: Dual assist line laser mount for K40

Hi,
i would just use 2 laserpointers with a dot, this has the benefit, that only if the two dots are at the same p... t-oster

2014-08-17

12:55 LAOS Laser Discussion and support: RE: Laser mis-fires ...

He is talking about the issue tracker of the LAOS project in Github: https://github.com/LaosLaser/Firmware/issues
... t-oster

2014-08-16

23:19 LAOS Laser Discussion and support: RE: Laser mis-fires ...

Hi,
I think those are related to engraving. I also had some of them: http://redmine.laoslaser.org/issues/47. Are y... t-oster

22:48 LAOS Laser Discussion and support: RE: VisiCut & Fractional speeds ...

Hi,
as you can see in VisiCut's source:
https://github.com/t-oster/LibLaserCut/blob/develop/src/com/t_oster/lib... t-oster

22:46 LAOS Laser Discussion and support: RE: Engraving tips?

Did you check VisiCut's "Additional space per Raster line" setting in the LAOS driver properties? It should add a bit... t-oster

2013-10-13

14:52 LAOS Laser Feature #46: Make the Z-Axis move synchronously

Since this issue make using the z-axis per software impossible, please point me in the right direction, where in the ... t-oster

14:23 LAOS Laser Bug #92: Z-axis jog function unusable

Hi...
as you see in the commit, I didn't change anything except the speed. So the only thing which I can think of is... t-oster

14:01 LAOS Laser Bug #92: Z-axis jog function unusable

Hi. Somebody I know also told me Z was moving together with X/Y, but I can't find the issue by just looking at the co... t-oster