LAOS - Laser Open Source

2013-05-06

22:10 LAOS Laser Discussion and support: RE: Fried mbed after pressing reset button

Hi,
drop me a line if you didn't get my email about some mbed support.
(email in my profile)
cheers
Dave Styles
... DaveStyles

2013-02-25

17:26 LAOS Laser Discussion and support: Pololu drivers. That current limiting pot they have.

Hi all..
Mine have a small pot on them, I had a look at the data sheet and it discusses setting current limiting u... DaveStyles

2013-02-22

19:22 LAOS Laser Discussion and support: RE: MBED SDK is now Open Source

Hi Peter,..
I think you've missed the point, they are releasing everything not just the SDK, they are releasing an o... DaveStyles

09:35 LAOS Laser Software development: RE: CodeCutter

Morning, I'm not near a laser, but the software appears to work / is great !
I can't believe I persevered with moshi... DaveStyles

2013-02-21

13:30 LAOS Laser Discussion and support: RE: K40III

One quick question then.
the flat connector.. where did you get one ? What is it ?
I've built and tested my boa... DaveStyles

2013-02-20

19:21 LAOS Laser Software development: Serial at 115200 baud. I'm having problems with that, ok at 9600 though.

Hi,..
I'm having problems with my PC talking to my mbed up at 115200, via teraterm when using the TEST firmware.
... DaveStyles

2013-02-19

22:53 LAOS Laser Discussion and support: RE: K40III

I have one that came with a moshiboard that melted.
It worked well till the control board melted. When I get it up... DaveStyles

22:51 LAOS Laser Software development: RE: Urgent : Tracked it down, but it's a worry. Doesn't compile with current mbed sdk. - FIXED

Thankyou Adam. and I mean THANKYOU !
Do you know I use the phrase "standing on the shoulders of giants" a LOT with... DaveStyles

2013-02-17

13:36 LAOS Laser Software development: RE: Urgent : Tracked it down, but it's a worry. Doesn't compile with current mbed sdk.

Ok, now I'm confused.
I think the rpc.h include was needed because there are some calls to rpc methods in the Netse... DaveStyles

2013-02-15

17:30 LAOS Laser Discussion and support: RE: Compiling on mbed.org - it doesn't - please help

bump DaveStyles