LAOS - Laser Open Source

2015-06-17

13:41 LAOS Laser Discussion and support: RE: I2C V0.4 Board Buzzer on constantly when powered on for testing (not hooked to laos board)

If I follow along with the screen on the board as well as the pictures on the instructions page, the orientation of t... Techrat

02:55 LAOS Laser Discussion and support: I2C V0.4 Board Buzzer on constantly when powered on for testing (not hooked to laos board)

The subject kind of says it all. Anyway, just soldered up my I2C v.4 board and was bench testing prior to hooking up ... Techrat

2013-05-29

21:22 LAOS Laser Wiki edit: A_list_of_users_with_LAOS_converted_lasercutters (#69)

Techrat

2013-05-13

18:02 LAOS Laser Discussion and support: RE: Switch Select PWM or Potentiometer power control on K40

Thanks for the feedback and alternative ideas!
I had considered only switching the control pin but upon review o... Techrat

04:30 LAOS Laser Discussion and support: Switch Select PWM or Potentiometer power control on K40

I have now had my K40 running with the LaOS board for a short while and am wanting to get the PWM set-up but was thin... Techrat

2013-05-04

23:29 LAOS Laser Discussion and support: RE: XDirection flipped when using Visicut with Laos board in K40

Daan,
Yes your fix is the one that worked. For myself, I had to change the <flipXaxis> to true in order to correct... Techrat

2013-05-03

04:11 LAOS Laser Discussion and support: XDirection flipped when using Visicut with Laos board in K40

Hi All,
I have just gotten my Laos board working in my K40 laser and am experiencing an issue that seems to have c... Techrat

2013-04-29

04:46 LAOS Laser Wiki edit: A_list_of_users_with_LAOS_converted_lasercutters (#61)

Techrat

2013-04-27

22:15 LAOS Laser Hardware development: RE: Warning: SD card might fall off on Rev4 boards!

I appear to have been able to hack this back together without too much difficulty, I am posting some images here to h... Techrat