LAOS Laser

h1. HPC LS3020 connections - July 2012

{{>toc}}

h2. Wiring diagram

Here is a schematic diagram of how everything should be wired up (from the "forum":/boards/1/topics/26):

!LaOS-wiring.jpg!

This is without PWM connected.

h2. Laser ON cable

The laser-on cable, as it comes shipped with the laser cutter needs to have one wire wire switched over, from this:

!DSC_3499.jpg!

... to this:

!DSC_3500.jpg!

h2. Y stepper cable

The Y stepper cable (with a 4-pin JST connector on the end) may be too short to reach the proper socket on the [[LAOS mainboard v0.3]] - this can be solved by manually splicing some extra wires, to extend it by about 15 cm:

!DSC_3647.jpg!