HPC LS3020 connections - July 2012 » History » Revision 5
Revision 4 (Anonymous, 2012-07-16 17:06) → Revision 5/16 (Anonymous, 2012-07-16 17:08)
h1. HPC LS3020 connections - July 2012
{{>toc}}
h2. Wiring diagram
Here is a schematic diagram of how everything should be wired up (from the "forum":/boards/1/topics/26):
!LaOS-wiring.jpg!
This is without PWM connected.
h2. Laser ON cable
The laser-on cable, as it comes shipped with the laser cutter needs to have one wire wire switched over, from this:
!DSC_3499.jpg!
... to this:
!DSC_3500.jpg!
h2. Y stepper cable
The Y stepper cable (with a 4-pin JST connector on the end) may be too short to reach the proper socket on the [[LAOS mainboard v0.3]] - this can be solved by manually splicing some extra wires, wires to extend it by about 15 cm: it:
!DSC_3647.jpg!