Wiki » History » Revision 13
Revision 12 (Anonymous, 2012-07-12 21:55) → Revision 13/86 (Anonymous, 2012-07-12 22:01)
h1. LAOS Laser
{{>toc}}
!>LaOSLogo.png!
This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of many [[Contributors]].
A laser cutter consists of several components, further described on the [[Overview]] page - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Supported lasers]] so far. The current electronics are [[Mainboard v0.3]] and [[i2cpanel vx.x]] - older versions are listed at the end of this page.
> Tip: for quick navigation, see the tabs at the top of each page on this site.
h2. HowTo's
* Figure out what you'll need and where to get it
* Prepare your laser cutter for use with LAOS (including first firing test)
* Assemble the LAOS electronics boards
* Install firmware and verify proper operation
* Connect the electronics and hook it up to your network
* Install required software on your Windows, Mac, or Linux pc
* Troubleshooting - Where to get help - Contributing to this wiki
h2. Reference
h3. [[Laser cutters]] Laser cutters
* HPC LS3020
* Materials and settings
h3. [[Electronics]]
* [[LAOS Mainboard v0.3]]
* I2cpanel vx.x
h3. [[Software]] Software
* LAOS firmware
* LAOS CUPS driver
* VisiCut
h3. Older information
...
h2. Useful links
...