Project

General

Profile

Wiki » History » Version 19

Anonymous, 2012-07-13 00:44

1 1 jaap
h1. LAOS Laser
2
3
{{>toc}}
4
5 10 Anonymous
!>LaOSLogo.png!
6 9 Anonymous
7 8 Anonymous
This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of many [[Contributors]].
8 1 jaap
9 18 Anonymous
A laser cutter consists of several components, further described on the [[Overview]] page - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Laser Cutters|Supported lasers]] so far. The current electronics are [[LAOS Mainboard v0.3]] and [[i2cpanel vx.x]] - older versions are listed on the [[Electronics]] page.
10 1 jaap
11 7 Anonymous
> Tip: for quick navigation, see the tabs at the top of each page on this site.
12 1 jaap
13
h2. HowTo's
14
15
* Figure out what you'll need and where to get it
16 2 jaap
* Prepare your laser cutter for use with LAOS (including first firing test)
17
* Assemble the LAOS electronics boards
18 1 jaap
* Install firmware and verify proper operation
19
* Connect the electronics and hook it up to your network
20 4 jaap
* Install required software on your Windows, Mac, or Linux pc
21 1 jaap
* Troubleshooting - Where to get help - Contributing to this wiki
22
23
h2. Reference
24
25 13 Anonymous
h3. [[Laser cutters]]
26 1 jaap
27 19 Anonymous
* How does a laser cutter work?
28 14 Anonymous
* [[HPC LS3020]]
29 1 jaap
* Materials and settings
30
31 12 Anonymous
h3. [[Electronics]]
32 1 jaap
33 19 Anonymous
* What is the electronics for?
34 11 Anonymous
* [[LAOS Mainboard v0.3]]
35 1 jaap
* I2cpanel vx.x
36
37 13 Anonymous
h3. [[Software]]
38 1 jaap
39 19 Anonymous
* Purpose of the software
40 15 Anonymous
* [[LAOS firmware]]
41 1 jaap
* LAOS CUPS driver
42
* VisiCut
43
44
h2. Useful links
45
46
...