Wiki » History » Version 2
jaap, 2012-07-12 11:53
| 1 | 1 | jaap | h1. LAOS Laser |
|---|---|---|---|
| 2 | |||
| 3 | {{>toc}} |
||
| 4 | |||
| 5 | This site is about an Open Source laser engraver/cutter controler system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of many [[Contributors]]. |
||
| 6 | |||
| 7 | A laser cutter consists of several components, further described on the [[Overview]] page - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Supported lasers]] so far. The current electronics are [[Mainboard v0.3]] and [[i2cpanel vx.x]] - check the [[Older electronics boards]] list for previous versions. |
||
| 8 | |||
| 9 | > Tip: for quick navigation on this site, see the tabs at the top of each page on this site. |
||
| 10 | |||
| 11 | h2. HowTo's |
||
| 12 | |||
| 13 | * Figure out what you'll need and where to get it |
||
| 14 | 2 | jaap | * Prepare your laser cutter for use with LAOS (including first firing test) |
| 15 | * Assemble the LAOS electronics boards |
||
| 16 | 1 | jaap | * Install firmware and verify proper operation |
| 17 | * Connect the electronics and hook it up to your network |
||
| 18 | * Install software on your windows, mac, or linux pc |
||
| 19 | * Troubleshooting - Where to get help - Contributing to this wiki |
||
| 20 | |||
| 21 | h2. Reference |
||
| 22 | |||
| 23 | h3.Laser cutters |
||
| 24 | |||
| 25 | * HPC LS3020 |
||
| 26 | * Materials and settings |
||
| 27 | |||
| 28 | h3. Electronics |
||
| 29 | |||
| 30 | * Mainboard v0.3 |
||
| 31 | * I2cpanel vx.x |
||
| 32 | |||
| 33 | h3. Software |
||
| 34 | |||
| 35 | * LAOS firmware |
||
| 36 | * LAOS CUPS driver |
||
| 37 | * VisiCut |
||
| 38 | |||
| 39 | h3. Older information |
||
| 40 | |||
| 41 | ... |
||
| 42 | |||
| 43 | h2. Useful links |
||
| 44 | |||
| 45 | ... |