Project

General

Profile

Wiki » History » Revision 35

Revision 34 (Anonymous, 2012-07-13 22:16) → Revision 35/86 (Anonymous, 2012-07-14 20:51)

h1. LAOS Laser 

 {{>toc}} 

 !>LaOSLogo.png! 

 This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of many [[Contributors]]. 

 A laser cutter consists of several components, further described on the [[Overview]] page - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Laser Cutters|Supported lasers]] so far. The current electronics are [[LAOS Mainboard v0.3]] and [[i2cpanel v0.3]] vx.x]] - older versions are listed on the [[Electronics]] page. 

 > Tip: for quick navigation, see the tabs at the top of each page on this site. 

 h2. HowTo's 

 * Figure out what you'll need and where to get it 
 * Prepare your laser cutter for use with LAOS (including first firing test) 
 * Assemble the LAOS electronics boards 
 * Install firmware and verify proper operation 
 * Connect the electronics and hook it up to your network 
 * Install required software on your Windows, Mac, or Linux pc 
 * Troubleshooting - Where to get help - Contributing to this wiki 

 h2. Reference 

 h3. [[Laser cutters]] 

 * How does a laser cutter work? 
 * [[HPC LS3020]] 
 * Materials and settings 

 h3. [[Electronics]] 

 * What is the electronics for? 
 * [[LAOS Mainboard v0.3]] 
 * [[I2cpanel v0.3]] I2cpanel vx.x 

 h3. [[Software]] 

 * Purpose of the software 
 * [[LAOS firmware]] 
 * LAOS CUPS driver 
 * [[VisiCut]] 

 h2. Useful links 

 * original wiki -    http://wiki.laoslaser.org/index.php/OpensourceLasercutterdriver