Wiki » History » Revision 36
Revision 35 (Anonymous, 2012-07-14 20:51) → Revision 36/86 (Anonymous, 2012-07-14 21:03)
h1. LAOS Laser
{{>toc}}
!>LaOSLogo.png!
This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of many [[Contributors]].
A laser cutter consists of several components, further described on the [[Overview]] page - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Laser Cutters|Supported lasers]] so far. The current electronics are [[LAOS Mainboard v0.3]] and [[i2cpanel v0.3]] - older versions are listed on the [[Electronics]] page.
> Tip: for quick navigation, see the tabs at the top of each page on this site.
h2. HowTo's
* Figure out what you'll need and where to get it
* Prepare your laser cutter for use with LAOS (including first firing test)
* Assemble the LAOS electronics boards
* Install firmware and verify proper operation
* Connect the electronics and hook it up to your network
* Install required software on your Windows, Mac, or Linux pc
* Troubleshooting - Where to get help - Contributing to this wiki
h2. Reference
h3. [[Laser cutters]]
* How does a laser cutter work?
* [[HPC LS3020]]
* Materials and settings
h3. [[Electronics]]
* What is the electronics for?
* [[LAOS Mainboard v0.3]]
* [[LAOS I2C Panel [[I2cpanel v0.3]]
h3. [[Software]]
* Purpose of the software
* [[LAOS firmware]]
* LAOS CUPS driver
* [[VisiCut]]
h2. Useful links
* original wiki - http://wiki.laoslaser.org/index.php/OpensourceLasercutterdriver