Wiki » History » Revision 41
Revision 40 (jaap, 2012-07-15 12:21) → Revision 41/86 (Anonymous, 2012-07-15 12:33)
h1. LAOS Laser
{{>toc}}
!>LaOSLogo.png!
This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of many [[Contributors]].
A laser cutter consists of several components, further described on the [Overview] page - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Laser Cutters|Supported lasers]] so far. The current electronics are [[LAOS Mainboard v0.3]] and [[LAOS I2C panel v0.3]] - older versions are listed on the [[Electronics]] page.
> Tip: for quick navigation, see the tabs at the top of each page on this site.
h2. HowTo's
* [Figure out what you'll need and where to get it]
* [Prepare your laser cutter for use with LAOS] LAOS (including a first firing test) test)]
* [Assemble the LAOS electronics boards]
* [Install firmware and verify proper operation]
* [Connect the electronics and hook it up to your network]
* [Install required software on your Windows, Mac, or Linux PC] pc]
* [Troubleshooting] [Troubleshooting - [Where Where to get help] help - [Contributing Contributing to this wiki]
h2. [[Laser cutters]]
* [[How does a laser cutter work?]]
* [[HPC LS3020]]
* [Materials and settings]
h2. [[Electronics]]
* [What is the electronics for?]
* [[LAOS Mainboard v0.3]]
* [[LAOS I2C Panel v0.3]]
h2. [[Software]]
* [[Software overview]]
* [LAOS firmware]
* [[LAOS CUPS driver]]
* [[VisiCut]]
h2. Useful links
* original wiki - http://wiki.laoslaser.org/index.php/OpensourceLasercutterdriver