Wiki » History » Revision 48
Revision 47 (Anonymous, 2012-07-16 17:23) → Revision 48/86 (Anonymous, 2012-07-16 17:35)
h1. LAOS Laser
{{>toc}}
!>LaOSLogo.png!
This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of many [[Contributors]].
A laser cutter consists of several components, as further described on the [[How does a laser cutter work?]] [Overview] page - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Laser Cutters|Supported lasers]] so far. The current electronics are [[LAOS Mainboard v0.3]] and [[LAOS I2C panel v0.3]] - older versions are listed on the [[Electronics]] page.
> Tip: for quick navigation, see the tabs at the top of each page on this site.
h2. [[HowTo's]]
* [Figure out what you'll need and where to get it]
* [Prepare your laser cutter for use with LAOS] (including a first firing test)
* [Assemble the LAOS electronics boards]
* [Install firmware and verify proper operation]
* [[Connect the electronics and hook it up to your network]]
* [Install required software on your Windows, Mac, or Linux PC]
* [[Troubleshooting]] - [Where to get help] - [Contributing to this wiki]
h2. [[Laser cutters]]
* [[How does a laser cutter work?]]
* [[HPC LS3020]]
* [[Materials and settings]]
h2. [[Electronics]]
* [What is the electronics for?]
* [[LAOS Mainboard v0.3]]
* [[LAOS I2C Panel v0.3]]
h2. [[Software]]
* [[Software overview]]
* [LAOS firmware]
* [[LAOS configuration file]]
* [[LAOS CUPS driver]]
* [[VisiCut]]
h2. Useful links
* original wiki - http://wiki.laoslaser.org/index.php/OpensourceLasercutterdriver