LAOS - Laser Open Source

2012-09-28

23:50 LAOS Laser Software development: RE: Towards an offline compiler

I'm not trying to make it work with gcc4mbed. I use the default gcc arm compiler.
The only thing I was not yet able ... markp

2012-09-27

23:45 LAOS Laser Software development: RE: Towards an offline compiler

I have spent some time preparing the code.
There are two issues to be resolved before I can publish:
- http://red... markp

23:42 LAOS Laser Software development: Differences mbed.org project, and git project for laser firmware

There are differences between the laoslaser projects published on mbed.org, and in the github project.
Attached is... markp

23:13 LAOS Laser Software development: FatFileSystem

I'm currently working on making the offline compilable source available for release, and have a small stumbling block... markp

2012-09-18

21:45 LAOS Laser Discussion and support: RE: Mainboard v0.3 Power Check

Does someone have an answer to this? markp

14:03 LAOS Laser Discussion and support: RE: Pin explanation

Ok, this is clear for me.
Just connect the PWM and pot in series.
The PWM signal goes throug the pot, where the vol... markp

10:27 LAOS Laser Discussion and support: RE: Pin explanation

Ok. That is good to know.
The dial is a potentiometer, with 3 pins connected.
The laser PWM has 2 pins.
Do you... markp

2012-09-17

19:08 LAOS Laser Discussion and support: RE: Pin explanation

Ok, thanks. This helps.
What kind of signal does the PWM have?
My laser has a manual analog dial to set the laser... markp

09:09 LAOS Laser Software development: RE: Towards an offline compiler

I will post code when I can.
My laos board is still under construction. First I will make sure the provided firmwa... markp

2012-09-16

14:09 LAOS Laser Software development: RE: Towards an offline compiler

I now was able to compile a bin file. I have no idea if it will work (probably not)
What I did was remove the ethe... markp