LAOS - Laser Open Source

2015-03-20

01:09 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Would it be possible for anyone to help me with this?
I'm now at a bit of a loss as to what to try next - and I'm ... jimjiminyjimjim

2015-03-02

23:27 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Ok so after extensive measurement and testing...
> Referring to the picture, please measure the following voltages... jimjiminyjimjim

2014-12-29

22:35 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Brilliant thanks - I'll be back in fronts of the laser cutter over the next couple of days - will make all the measur... jimjiminyjimjim

21:49 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Great - thanks for the reply - its much appreciated. I'm keen to sort this.
I think my confusion in diagnosing thi... jimjiminyjimjim

13:24 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Ok - I'm determined to get my laser cutter up and running as is been sitting on the workbench in pieces.
Quick sum... jimjiminyjimjim

2014-09-07

13:59 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Is there anyone that can help me with this? I'd really like to get the board up and running - but I'm not really sure... jimjiminyjimjim

2014-07-08

17:05 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Ok so after more investigation and double checking I'm not sure I do know whats going on.
There are 4 pins on the ... jimjiminyjimjim

2014-06-14

10:40 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

So I checked the continuity on the flat cable connections and it looks like its using Pin 2 instead of Pin 4 for Yhom... jimjiminyjimjim

2014-05-24

18:37 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

Hi
So I've checked these readings...
- GND and VEndStops is about 4.7- 5 volts
- GND and XHome - is 0.3 unless... jimjiminyjimjim

2014-05-23

19:53 LAOS Laser Discussion and support: RE: Setting up LS3020 & homing issues

So I've finally removed the laser frame form the casing -
I measured the voltage on the old board when the endsto... jimjiminyjimjim