LAOS - Laser Open Source

2014-08-23

13:28 LAOS Laser Software development: RE: Firmware with boundary function

It appears to work on my HPC.
A very worthwhile addition IMO.
One minor niggle - I think it would be good to le... drogon

2014-08-20

22:53 LAOS Laser Discussion and support: Videoing...

Not that exciting, but I was playing with the Raspberry Pi Noir Camera and stuck it inside my cutter and ran some c... drogon

2014-08-17

20:31 LAOS Laser Discussion and support: RE: Laser mis-fires ... Sorted - FSVO Sorted ...

On a whim, I decided to take my original in Inkscape and take the bottom 3 lines - the ones in the photo above which ... drogon

16:28 LAOS Laser Discussion and support: RE: Laser mis-fires ...

The firmware I have is the laoslaser-14-05-2014.bin version. That's what the link on the wiki points to.
I do noti... drogon

12:39 LAOS Laser Discussion and support: RE: Laser mis-fires ...

This github? https://github.com/peteruithoven/SimpleCodePreviewer
Would really like to get to the bottom of these ... drogon

2014-08-16

23:49 LAOS Laser Discussion and support: RE: Laser mis-fires ...

Last try before bed... Went back into Inkscape, trying to follow the issue 58.. nothing was grouped, but I selected a... drogon

23:26 LAOS Laser Discussion and support: RE: Laser mis-fires ...

Hm. I'll have a look at that issue - and re-do the Inkscape file tomorrow.
However I've just run another cut using... drogon

23:00 LAOS Laser Discussion and support: Laser mis-fires ...

Just when I thought it was going really well...
I've noticed for some time what looks like the occasional "scratch... drogon

22:52 LAOS Laser Discussion and support: RE: Engraving tips?

No - not found that one, but a-ha... Settings -> Lasercutters -> LAOS and there it is. I'll have a play with that, th... drogon

22:37 LAOS Laser Discussion and support: RE: Engraving tips?

I'll reply to myself as I think I've worked this one out - at least some of it.
More speed, less laser power!
J... drogon