HackerspaceFFM
- Email: lados.9.keks@spamgourmet.com
- Registered on: 2014-10-25
- Last connection: 2014-11-20
Issues
Projects
- LAOS Laser (Developer, 2014-11-21)
Activity
2014-11-09
- 23:07 LAOS Laser Software development: RE: Fix to make engrave speed setting working
- Hi,
for clarification: Actually the speed setting from Visicut is operates like that:
Cut & Mark Speed = config.txt... - 21:27 LAOS Laser Hardware development: RE: Modifications for high speed PWM and laser control outputs
- The optocouplers currently used in the LAOS design are damn slow - I saw considerable signal issues at even a few kHz...
- Hi,
within the current firmware engraving is done always with 100% speed (xspeed and xaccel is used), regardless of ... - Hi,
since quite a while we have converted our china K40-III laser cutter to Laos. As we killed the original laser tu...
2014-10-27
- 13:22 LAOS Laser Software development: RE: Make cancel button working using MODI2C
- Hi,
unfortunately it does not seem such easy. :-(
I think I have to withdraw that software because after some time...
2014-10-26
- Hi,
I've played with the firmware and changed I2C by MODI2C. Everything is working again, but now by using a new non... - 20:26 LAOS Laser Discussion and support: RE: Laser mis-fires ...
- Hi,
I tested it now myself and it works with the new Firmware. Cancel button now also, but I start a new thread for ... - 12:54 LAOS Laser Discussion and support: RE: Laser mis-fires ...
- Hi,
I will test it also in a few hours today when I am in the hackerspace. I think I've managed to set up a build en...
2014-10-25
- 16:57 LAOS Laser Discussion and support: RE: Laser mis-fires ...
- Hi Peter,
yes I can test it, if not today than within next 2 days. By uploading the drei.lgc file it should be repro... - 16:16 LAOS Laser Discussion and support: RE: Laser mis-fires ...
- Hi,
we at Hackerspace-FFM successfully converted our China-Laser K40-III to Laos. When voting for doing the conver...
Also available in: Atom