LAOS - Laser Open Source

2015-03-22

21:56 LAOS Laser Software development: RE: Engraving acceleration problem

solved problem as you said thanks peter :) asenyurt

21:12 LAOS Laser Software development: RE: Engraving acceleration problem

ouuw i need to find which pin on laser PSU asenyurt

21:07 LAOS Laser Software development: RE: Engraving acceleration problem

can i connect same schematic which i added picture last post ? just change MBED pin ? asenyurt

21:03 LAOS Laser Software development: RE: Engraving acceleration problem

asenyurt wrote:
> i connetted just Laser ON signal 5th pin on MBED
> should i connect Laser PWM or enable ?
i co... asenyurt

21:02 LAOS Laser Software development: RE: Engraving acceleration problem

i connetted just Laser ON signal 5th pin on MBED
should i connect Laser PWM or enable ? asenyurt

20:27 LAOS Laser Software development: RE: Engraving acceleration problem

i am adjusting analog pontentiometer asenyurt

18:48 LAOS Laser Software development: RE: Engraving acceleration problem

sample photo again asenyurt

18:31 LAOS Laser Software development: Engraving acceleration problem

Hi everyone
I built my board and connected to my K40 machine with Moshiboard. Worked perfect
but i have problem wit... asenyurt

2015-03-19

17:35 LAOS Laser Discussion and support: RE: Questions for Beginners

today i got mail from moral beng
he said you have to put pullup resistors to sda scl pins and you have to trigger th... asenyurt

2015-03-18

23:00 LAOS Laser Discussion and support: RE: Questions for Beginners

nothing i am too far Netherlands and i have to do some works with my laser machine
i dont understand why didnt wor... asenyurt