LAOS - Laser Open Source

2016-11-15

21:05 LAOS Laser Discussion and support: RE: OT: What water pump are you using?

using a small fishtank pump, perhaps if you add a flow detector and a temp sensor on the tank, can get an idea if the... jegb

21:00 LAOS Laser Wiki edit: A_list_of_users_with_LAOS_converted_lasercutters (#89)

jegb

20:58 LAOS Laser Wiki edit: Z_height_control (#1)

jegb

2016-01-29

08:32 LAOS Laser Discussion and support: RE: laser.on in config.txt is ignored??

I tested this and it works. the macro needs to be in pins.h not LaosMotion.h though. jegb

2016-01-23

23:05 LAOS Laser Software development: RE: Webbased lasercutter control

Agreed, web interface is handy. if LaOS would run gcode "octopi-octoprint":http://docs.octoprint.org/en/master/ is a... jegb

12:26 LAOS Laser Software development: RE: Webbased lasercutter control

seems like a fork of "Chillipepr":http://chilipeppr.com/grbl
I have tried this one and Inventable's "easel": http:/... jegb

2016-01-13

12:58 LAOS Laser Discussion and support: RE: laser.on in config.txt is ignored??

LaosMotion.h currently includes this macro:
#define LASERON 0 //logic is Active LOW, Idle HIGH (pull up)
#define L... jegb

07:39 LAOS Laser Discussion and support: RE: laser.on in config.txt is ignored??

I am at this point too now, everything works except laser on (in my case is active high).
Would be possible to chang... jegb

07:47 LAOS Laser Discussion and support: RE: Questions from a Newbie (Before Purchase)

Thats good price, that table you can purchase normally 25-30€, best price from aliexpress. jegb

2016-01-12

16:59 LAOS Laser Discussion and support: RE: receive file

did not work, testing the header pin #4 with the reset pin on the push button is not connected.
According to "this... jegb