Project

General

Profile

Forums » Discussion and support »

SD not ready

Added by bartb over 12 years ago

Are installing the cutter at Martine's
Everything functions, but it does not accept jobs.
When booting "SD NOT READY" appears,
followed by the normal sequence of config ok, IP address , homing etc.
Different SD card gives the same message.


Replies (4)

RE: SD not ready - Added by Anonymous over 12 years ago

Jaap told me "SD not ready" is a known issue, the mbed restarts until it is ready. So when you get CONFIG OK, etc, that problem has been resolved.

Does the VisiCut IP address match up with what LAOS reports?

RE: SD not ready - Added by Martine over 12 years ago

Ip address matches...
wifi shut off

something else I could try?

RE: SD not ready - Added by Anonymous over 12 years ago

Not sure - might be something with the network setup/config, I've opened a separate discussion about this - see Problems connecting to the laser cutter

RE: SD not ready - Added by Martine over 12 years ago

It works!

We connected the laser directly to the computer. This is wrong.
It only works in the network.

    (1-4/4)