Last call for revision 4

We're running out of boards, so it's time to get a new batch.

Somewhere next week I will take a good look at the issue tracker and see what will be in Rev 4. So if you have things to add, now would be a good time to post something on the issue tracker.

(please do not post suggestions in the forum).

I will be working on the board in KiCad. If someone wants to review the board before it goes to Eurocircuits, please let me know!

Replies (3)

RE: Last call for revision 4 - Added by jaap over 11 years ago

The design for Rev4 has been made. The board has been uploaded to GitHub.

We need volunteers to have a good look at the board... please open the design in KiCAD and see if you find any (new?) bugs!

End of the week, I will order a new batch from Eurocircuits.

RE: Last call for revision 4 - Added by jaap over 11 years ago

For KiCAD noobs, both the schematics and the board are available as SVG in GitHub:

https://github.com/LaosLaser/Hardware/blob/master/laos-board-rev4/laos-board-brd.svg

and

https://github.com/LaosLaser/Hardware/blob/master/laos-board-rev4/laos-board.svg

RE: Last call for revision 4 - Added by peter over 11 years ago

Jaap: a few remarks: see issues.
1) 3v3 jumper is not required
2) Silkscreen location of MBED usb connector (and pin1)
3) 3v3 power requirement (>250mA) or place 5V on pololus (test?)
4) decoupling capacitors on pololus (underneath)

(1-3/3)

Project

General

Profile

LAOS Laser