Actions
Materials and settings » History » Revision 4
« Previous |
Revision 4/5
(diff)
| Next »
bartb, 2012-07-16 08:56
Materials and settings¶
Table for LS3020 from HPC
Cut frequency always 500, for perspex (=acrylic) 5000
| Material | Cut vector |
Engrave raster |
|||
|---|---|---|---|---|---|
| Speed | Power | Speed | Power | ||
| Acrylic 2mm | 100 | 200 | 21 | ||
| Acrylic 3mm | 6 | 100 | 200 | 21 | |
| Acrylic 4mm | 100 | 200 | 21 | ||
| Acrylic 5 mm | 3 | 100 | 200 | 21 | |
| Acrylic 10 mm | 1 | 100 | 200 | 21 | |
| Triplex 1,5 mm | 8 | 100 | 200 | 17 | |
| Triplex 3 mm | 5 | 100 | 200 | 17 | |
| Triplex 4 mm | 100 | 200 | 17 | ||
| Triplex 5 mm | 2 | 100 | 200 | 17 | |
| Triplex 6 mm | 1 | 100 | 200 | 17 | |
| MDF 3 mm | 5 | 100 | 200 | 25 | |
| MDF 4 mm | 4 | 100 | 200 | 25 | |
| MDF 6 mm | 100 | 200 | 25 | ||
| Corr. Cardboard 3 mm | 12 | 100 | 200 | 20 | |
| Hardboard 3 mm | 3 | 100 | 200 | 20 | |
| Paper | 20 | 20 | 200 | 15 | |
| Card | 25 | 40 | 200 | 20 | |
| Mount Board | 12 | 100 | 200 | 20 | |
| Engraving Laminate | 15 | 80 | 200 | 21 | |
| Funky Foam | 25 | 25 | no engrave | ||
Tip:
to get a better result from engraving: slow the speed down
Updated by bartb over 12 years ago · 4 revisions