LAOS Laser

h1. LAOS Laser

{{>toc}}

!>LaOSLogo.png!

This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the [[Rationale and background]] page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of other [[Contributors]].

A laser cutter consists of several components, as described on [[How does a laser cutter work?|this page]] - this site focuses on units such as the [[HPC LS3020]], in combination with the LAOS electronics. For a full list, see the [[Laser Cutters|Supported lasers]] so far. The current electronics are [[LAOS Mainboard v0.3]] and [[LAOS I2C panel v0.3]] - older versions are listed on the [[Electronics]] page.

> Tip # 1: for quick navigation, see the tabs at the top of each page on this site.

> Tip # 2: click on the section titles below for a list of all the pages related to that section.

h2. [[HowTo's]]

* [Figure out what you'll need and where to get it]

* [Prepare your laser cutter for use with LAOS] (including a first firing test)

* [Assemble the LAOS electronics boards]

* [Install firmware and verify proper operation]

* [[Connect the electronics and hook it up to your network]]

* [Install required software on your Windows, Mac, or Linux PC]

* [[Troubleshooting]] - [Where to get help] - [Contributing to this wiki]

h2. [[Laser cutters]]

* [[How does a laser cutter work?]]

* [[HPC LS3020]]

* [[Materials and settings]]

* [[A list of users with LAOS converted lasercutters]]

h2. [[Electronics]]

* [[What is the electronics for?]]

* [[LAOS Mainboard v0.3]]

* [[LAOS I2C Panel v0.3]]

h2. [[Software]]

* [[Software overview]]

* [[LAOS firmware]]

* [[LAOS configuration file]]

* [[LAOS CUPS driver]]

* [[VisiCut]]

h2. Additional information

* [Historical notes]

* original wiki -  http://wiki.laoslaser.org/index.php/OpensourceLasercutterdriver

* [[Links]]