Project

General

Profile

Actions

Bug #70

open

K40 Y-stepper docs confusing

Added by trj about 11 years ago. Updated over 9 years ago.

Status:
New
Priority:
Normal
Assignee:
-
Category:
Documentation
Target version:
-
Start date:
2013-01-08
Due date:
% Done:

0%

Estimated time:

Description

I'm trying to test my K40 with LaOS by wiring up the Y stepper and using the iotest firmware.
But, the documentation for the pinout is confusing.

http://redmine.laoslaser.org/projects/laos/wiki/K40-III

Says:

Color Signal Connect to
RED XA+ J18.2 A
BLUE XA- J18.3 A
YELLOW XB+ J18.4 B
WHITE XB- J18.5 B

a) These should be YA and YB.
b) On the schematic J18.1 is YA+, J18.5 is GND.

How should it be connected?

Actions #1

Updated by peteruithoven over 9 years ago

  • Category set to Documentation
Actions

Also available in: Atom PDF