Actions
Bug #82
closed
Non-Pololu only assembly unclear?
Status:
Rejected
Priority:
Normal
Assignee:
-
Category:
Documentation
Target version:
-
Start date:
2013-05-08
Due date:
% Done:
0%
Estimated time:
Description
I'm converting a Morntech lasercutter to Laos. It already has stepper drivers so I'm trying to use those.
I find the following unclear though.
Some voltage: you can use Vmot by filling the solder pad under the connector (the square pole is +). If you need 3V3 you can make a wire between the pololu pins (10) and (14). If you need 5V, you can make a wire from a 5V net to pololu pin (14).
I don't have pololu's, so I'm not sure what pins are pololu pin 10 and 14.
If someone could explain I'll take a picture of the setup.
Updated by
Actions