Materials and settings » History » Revision 2
Revision 1 (bartb, 2012-07-15 17:29) → Revision 2/5 (bartb, 2012-07-15 23:31)
h1. Materials and settings Table for LS3020 from HPC Cut frequency always 500, for perspex (=acrylic) 5000 |_. *Material*|\2=.*Cut* vector|\2=. *Engrave* raster| |_.|_. Speed|_.Power|_. Speed|_.Power|| Power|_.Speed|_. Power|_.Speed| |Acrylic 2mm|_.|=.100|=.21|=.200| |Acrylic 3mm|=.6|=.100|=.21|=.200| |Acrylic 4mm|_.|=.100|=.21|=.200| |Acrylic 5 mm|=.3|=.100|=.21|=.200| |Acrylic 10 mm|=.1|=.100|=.21|=.200| |Triplex 1,5 mm|=.8|=.100|=.17|=.200| |Triplex 3 mm|=.5|=.100|=.17|=.200| |Triplex 4 mm|_.|=.100|=.17|=.200| |Triplex 5 mm|=.2|=.100|=.17|=.200| |Triplex 6 mm|=.1|=.100|=.17|=.200| |MDF 3 mm|=.5|=.100|=.25|=.200| |MDF 4 mm|=.4|=.100|=.25|=.200| |MDF 6 mm|_.|=.100|=.25|=.200| |Corr. Cardboard 3 mm|=.12|=.100|=.20|=.200| |Hardboard 3 mm|=.3|=.100|=.20|=.200| |Paper|=.20|=.20|=.15|=.200| |Card|=.25|=.40|=.20|=.200| |Mount Board|=.12|=.100|=.20|=.200| |Engraving Laminate|=.15|=.80|=.21|=.200| |Funky Foam|=.25|=.25|\2=.no engrave| Tip: to get a better result from engraving: slow the speed down