LAOS - Laser Open Source

2015-04-29

15:43 LAOS Laser Discussion and support: Need ATMega 168P-20PU with boot loader installed..........

Has anyone in the USA or Canada an extra one that they are willing to sell? Rolf

2014-07-23

18:21 LAOS Laser Discussion and support: RE: IP address problems...........

Thank you Gordon. My little gray cells are 85 and I have a hard time trying to recall everything that's going on.
Th... Rolf

17:42 LAOS Laser Discussion and support: IP address problems...........

I have had a terrible time trying to find the correct IP address for the MBED. After some research I found the comman... Rolf

2014-07-11

17:00 LAOS Laser Discussion and support: RE: New HPC LS 3020 Setup

I am also having problems with correctly installing the µSD card connector. It would be nice if future boards could h... Rolf

16:44 LAOS Laser Wiki edit: A_list_of_users_with_LAOS_converted_lasercutters (#72)

Rolf

2014-06-17

15:38 LAOS Laser Discussion and support: RE: New Laos Laser up and running!

For some reason I was under the impression that the Laos MBED was controlled through the USB port. I did not even ins... Rolf

2014-06-16

20:43 LAOS Laser Discussion and support: RE: New Laos Laser up and running!

The DHCP should is now one (1), should I change that to zero. How to identify the IP that is assigned to it?
When I ... Rolf

2014-06-15

20:32 LAOS Laser Discussion and support: RE: New Laos Laser up and running!

Steve, I don't have the ribbon cable or display. I consider my board finished.
When I send the job from Visicut I ge... Rolf

14:55 LAOS Laser Discussion and support: RE: New Laos Laser up and running!

sweaving wrote:
> Hello all,
> just thought i would introduce myself!
>
> After having bought a Rev 5 board prob... Rolf

2014-06-02

21:26 LAOS Laser Discussion and support: RE: Making the config.txt file work..............

I guess I should've clarified in my initial post that the message I was referring to was on the PC monitor screen. I ... Rolf