General

Profile

darrenp

Issues

Projects

Activity

2014-08-29

21:47 LAOS Laser Software development: RE: Random Laser ON at engrave
I've had similar problems, and I think it is LaOS related rather than visicut. I've more or less got rid of it by red...

2013-10-19

20:56 LAOS Laser Discussion and support: Cutter freezing randomly
Hey,
Been cutting/engraving fine for the last few months, but just in the last week have hit an issue. At some poi...

2013-03-02

20:48 LAOS Laser Discussion and support: RE: Constant resets when i2c board is attached.
One question, is debug enabled on the arduino sketch for the display? I had issues with the cutter not working if deb...
19:39 LAOS Laser Discussion and support: RE: Test LaserScript
Fantastic work. Just installed the nightly of Visicut, upgrading from 1.5, and its already solved a few issues I was ...

2013-02-22

10:04 LAOS Laser Discussion and support: RE: K40III
This is what I bought:
https://uk.rs-online.com/web/p/fpc-connectors/7188772/
Just make sure you get it the rig...

2013-02-21

13:15 LAOS Laser Discussion and support: RE: K40III
Oh, hugomeiland: I'll give that a try this weekend. It doesn't seem too bad to be honest. Managed to cut through 6mm ...
13:14 LAOS Laser Discussion and support: RE: K40III
There was no way I could use the moshi software long enough for it to melt! It was barely plugged in enough to let me...

2013-02-19

20:21 LAOS Laser Wiki edit: K40-III_Material_Settings (#7)
20:19 LAOS Laser Discussion and support: RE: K40III
Indeed I have. I'm working on documenting it in the wiki now.
20:18 LAOS Laser Wiki edit: K40-III_Material_Settings (#6)

Also available in: Atom