LAOS Laser

I think it is a wonderful idea.

If possible also leave provision for later to have a non linear integration of tube use depending on the tube current or percentage. Perhaps to start use 1% power to equate to 50% tube wear and 100% power to equate to 100% tube wear. There may be a wear profile documented out there. You could also add in the number of time the tube is ignited. If this causes more wear than holding the tube at just below lasing current then one could decide to use 0.1% power setting when making rpid moves instead of disabling the tube powersupply completely, it might even allow for faster beam on time, it could be of use in the raster marking setup as well so the beam is never completely off.

So one could list the following

Tube on hours
Rapid moves hours
Paused hours (errors, waiting for host, ?)
Total operating hours

Tube savings hours (correction for lower tube currents)
Tube strikes
Tube strike effective wear hours (estimated life lost due to total of strikes)

Total Tube Use (some kind combination of the above)

This would allow you to decide when you should order your replacement tube based on the life of the first tube you had.

The detailed logging you propose only seems relevant is tube life varies only minimally between tubes. As I understand, the tube gradually wears out and loses power, so having a rough indication of laser on-time is probably enough to get a sense of how old the tube is.