Project

General

Profile

Actions
Copy link

Bug #34

closed

job regularly hangs

Added by Anonymous over 12 years ago. Updated over 11 years ago.

Status:
Closed
Priority:
Normal
Assignee:
-
Category:
firmware
Target version:
-
Start date:
2012-08-25
Due date:
% Done:

0%

Estimated time:

Description

From the forum, file stops running:

When I execute a file, it stops running at some point.
Never the same point in the file, though.
The display still says: RUNNING 1%
But the machine quits.It doesn't resume.

I've also observed this on my laser cutter, problem is definitely intermittent and hard to reproduce reliably.

Seems like either a hardware or a firmware interrupt problem, since the same job doesn't always hang, nor in the same place.

Might be an idea to set up a single test job which hangs, and then try it on different units.

This also brings up the need for a diagnostic mode (w/ docs), so that we have at least some chance of figuring problems like this out.

Actions
Copy link

Also available in: Atom PDF