LAOS Laser

Yes sometimes its get stuck at RUNNING 1% (the display does not get updated very often btw).
Does not happen very often, most of the time i send the file again, but thats nasty.
This is a bug in de firmware i think (maybe we should make a New Issue out of this one)

Unfortunately I wouldn't say it's rare...

Just counted today: out of ten executes on the same file I have 3 runs that DON'T stop.
That means a failure of 70%. Maybe the file is difficult?

The SVG file is not really big - It should run around 2.5 minutes (speed 20), and is 10Kb.
It hasn't stopped once at the same spot.

Sending again is a good option, opening the lid to prevent burn marks on the already cut parts, closing it as soon as it should start cutting again.
Ha, but nasty it is.

It's a pity I don't know nothing about firmware.
I hope sharing experience can help a tiny bit:)

I've added this as issue #34 in the issue tracker, because IMO everything that needs / ought to be resolved belongs there. Forum posts tend to sink to the bottom of the ocean over time.

Thanks for the addition of the bug report.
See my comments there.