Wiki » History » Revision 75

« Previous | Revision 75/86 (diff) | Next »
jaap, 2013-03-14 22:08

LAOS Laser¶

Table of contents
LAOS Laser

This site is about an Open Source laser engraver/cutter controller system, both hardware and software. Further info can be found on the Rationale and background page. The site was created in 2010 by Jaap Vermaas and Peter Brier, and is now being taken further with the help of other Contributors.

A laser cutter consists of several components, as described on this page - this site focuses on units such as the HPC LS3020, in combination with the LAOS electronics. For a full list, see the Supported lasers so far. The current electronics are LAOS Mainboard v0.3 and LAOS I2C panel v0.3 - older versions are listed on the Electronics page.

Warning: If you have Rev4 board, read http://redmine.laoslaser.org/issues/68

To avoid confusion, these versions are current:

LAOS Mainboard: v0.4 (with patch)
LAOS I2C panel: v0.3
LAOS firmware: v0.3 (latest bin 9-3-2013)

Tip # 1: for quick navigation, see the tabs at the top of each page on this site.
Tip # 2: click on the section titles below for a list of all the pages related to that section.